搜索结果: 1-6 共查到“Ceramic particles”相关记录6条 . 查询时间(0.119 秒)
Composite materials based on EN AW-Al Cu4Mg1(A) aluminum alloy reinforced with the BN ceramic particles
Aluminum alloy Composite materials Powder metallurgy Corrosion resistance Polarisation curve Abrasive wear
2010/8/17
Considerable attention is focused on metal matrix reinforced with strength and high modulus ceramic reinforcements because of their superior properties in comparison with most of conventional material...
Experimental investigation of viscosity and thermal conductivity of suspensions containing nanosized ceramic particles
I. Tavman A. Turgut M. Chirtoc H.P. Schuchmann S. Tavman
2009/12/2
Purpose: In this study we report measurements of effective thermal conductivity by using 3ω method
and effective viscosity by vibro-viscometer for SiO2-water and Al2O3-water nanofluids at different p...
Fabrication and characterization of TiAl/Ti3Al-based intermetallic composites (IMCs) reinforced with ceramic particles
Composites TiAl
2010/8/16
TiAl/Ti3Al-based alloys have several advantages over conventional titanium alloys, such as higher elastic modulus, lower density, better mechanical properties at elevated temperatures, and higher oxid...
Solidification analysis of AMMCs with ceramic particles
Composites Casting Solidification analysis Silicon carbide
2009/12/1
Purpose: In the research work the result of the reinforcement displacement and solidification analysis for aluminium
cast composites with ceramic particles have been presented. The results of researc...
Wear resistance of PM composite materials reinforced with the Ti(C,N) ceramic particles
Composites Mechanical properties Abrasive wear
2010/2/4
Purpose: of the project was evaluation of the effect of heat treatment and of the reinforcing Ti(C,N) particles in the EN AW-AlCu4Mg1(A) aluminium alloy on the mechanical properties, wear resistance.D...
Influence of hard ceramic particles on structure and properties of TGM
Cemented carbides Tool Gradient Materials Powder Metallurgy
2010/2/9
Purpose: The Powder Metallurgy route has been chosen to fabricate tool gradient materials with high disproportion of cobalt matrix portion between core and surface layer. In the paper structure and pr...