工学 >>> 力学 农业工程 林业工程 工程与技术科学基础学科 测绘科学技术 材料科学 矿山工程技术 石油与天然气工程 冶金工程技术 机械工程 光学工程 仪器科学与技术 动力与电气工程 能源科学技术 核科学技术 电子科学与技术 信息与通信工程 控制科学与技术 计算机科学技术 化学工程 纺织科学技术 印刷工业 服装工业、制鞋工业 轻工技术与工程 食品科学技术 土木建筑工程 水利工程 交通运输工程 船舶与海洋工程 航空、航天科学技术 兵器科学与技术 环境科学技术 安全科学技术 工业设计
搜索结果: 1-15 共查到工学 Intermediate相关记录17条 . 查询时间(0.031 秒)
It is innovative and important to perform complex binary azeotrope separation via single distillation column. In the article, design and control of a novel and simple side-stream extractive distillati...
The side-stream extractive distillation (SSED) system is attracting widespread attention due to its high eco-efficiency. In the article, three double-column SSED (DC-SSED) sequences and two single-col...
Hybrid quantum systems usually consist of two or more subsystems, which may take the advantages of the different systems. Recently, the hybrid system consisting of circuit electromechanical subsystems...
Digital Elevation Models (DEM) represent fundamental data for a wide range of Earth surface process studies. Over the past years the German TanDEM-X mission acquired data for a new, truly global Dig...
Recently a preliminary version of the new global DEM collected by the TanDEM-X mission became available to the scientific community: the TanDEM-X Intermediate DEM (IDEM) version. It is available over ...
The German Aerospace Center (DLR, Deutsches Zentrum für Luft- und Raumfahrt) currently conducts the bistatic interferometric synthetic aperture radar (SAR) Mission TanDEM-X, which shall result in a DE...
A complete high precision set of deuteron analyzing powers for elastic deuteron-proton ($dp$) scattering at 250 MeV/nucleon (MeV/N) has been measured. The new data are presented together with data fro...
Response surface methodology (RSM) was used for selecting optimal fermentation time and initial sugar mass fraction in cultivation media based on raw juice from sugar beet in order to produce ethano...
Much attention has been devoted to efforts to operate polymer electrolyte fuel cells (PEFCs) at temperatures above 100°C in order to avoid the problem of serious CO poisoning of the anode catalyst. It...
Fuel cells are attractive energy conversion devices with high efficiencies and low emissions, and many studies have been conducted so far. Among them, fuel cells operating at 200-600°C are promising t...
The Ti/SnO2+Sb2O3/PbO2 anode with SnO2+Sb2O3 intermediate layer obtained by the polymeric precursor method (PPM) and with the conventional route was studied. The morphology and microstructure of SnO2+...
Reduction of NO by CO is one of the most important reactions that take place in catalytic converters,during the purification of exhaust gas of motor vehicles. Despite the fact that this reaction has b...
Biltong, cabanossi, dry sausage, salami are typical intermediate moisture meats produced and consumed to a large extent in South Africa. A study was undertaken with the objective of isolating and iden...
This paper describes a method which can be adopted to improve the torsional and also distortional strength of thin-walled cold-formed steel columns used in pallet racking systems. Elastic buckling ana...
The introduction of a third component into planar photonic crystal waveguides definitely influences the properties of linear defect modes, such as the band diagram, intrinsic loss, group velocity and ...

中国研究生教育排行榜-

正在加载...

中国学术期刊排行榜-

正在加载...

世界大学科研机构排行榜-

正在加载...

中国大学排行榜-

正在加载...

人 物-

正在加载...

课 件-

正在加载...

视听资料-

正在加载...

研招资料 -

正在加载...

知识要闻-

正在加载...

国际动态-

正在加载...

会议中心-

正在加载...

学术指南-

正在加载...

学术站点-

正在加载...